Page 1 of 1

bladeRF x40 Ham radio

Posted: Thu Jul 27, 2017 10:34 pm
by jxgreen5
Hello,
I am considering purchasing a bladeRF x40 and was wondering if it can be used to transmit and revive ham waves. I was also wondering if Yate and YateBTS are like openBTS.

Re: bladeRF x40 Ham radio

Posted: Tue Aug 01, 2017 12:55 pm
by bglod
The bladeRF will require the XB-200 transverter to access frequencies below 300 MHz. The XB-200 will let you get down to tens of KHz. It has on-board filters for 50-54 MHz (6m band), 149-159 MHz, and 206-235 MHz. There is also a custom filter path that will let you install your own filter, if needed.

YateBTS is similar to OpenBTS in that it is a GSM base station software. Both support bladeRF.

Re: bladeRF x40 Ham radio

Posted: Fri Aug 04, 2017 7:55 am
by rshill
I'm selling my SDR with transverter board for $195. This would give you the ability to access HAM bands.

https://www.tindie.com/products/rshill/ ... ter-board/

Re: bladeRF x40 Ham radio

Posted: Fri Aug 04, 2017 3:44 pm
by jxgreen5
What type of microphone could i use to transmit and recive ham bands? Also what software is capable of doing such that along with reciving waves? Is YateBTS legal and how would you program a sim card?

Re: bladeRF x40 Ham radio

Posted: Fri Aug 11, 2017 12:27 pm
by bglod
Our SDR interfaces with a computer host. You can use any microphone that a computer can use. For software, Gqrx or GNU Radio would work. These are Linux applications.

YateBTS (and other BTS software) is legal if you're operating in ISM bands under the power limitations set forth by your local governing body for those band(s). If you want to operate on other bands, you'd need a license. Licenses are only required when transmitting. You can receive all you want without a license. Note that operating a rogue base station on a commercial GSM/LTE/etc. band is highly illegal and not recommended.

To setup a SIM card, etc. refer to the folks and documentation over at YateBTS as that's their area of expertise.

Re: bladeRF x40 Ham radio

Posted: Tue Aug 15, 2017 2:36 pm
by jxgreen5
So I would need a license to make calls over a yatebts network?