Refresh quick tune
Posted: Thu Mar 02, 2023 1:26 am
Hi,
I am writing a program, that sweeps over a range of frequencies many times a second and uses quick tune parameters to lower the tuning times. In the documentation it says:
[ERROR @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:1417] Reached maximum number of RX quick tune profiles.
Is there a different way to refresh the quicktune parameters?
I am writing a program, that sweeps over a range of frequencies many times a second and uses quick tune parameters to lower the tuning times. In the documentation it says:
To refresh the parameters i tried calling bladerf_get_quick_tune() again, but after some time I get this error:Note
These parameters are sensitive to changes in the operating environment, and should be "refreshed" if planning to use the "quick retune" functionality over a long period of time.
[ERROR @ host/libraries/libbladeRF/src/board/bladerf2/bladerf2.c:1417] Reached maximum number of RX quick tune profiles.
Is there a different way to refresh the quicktune parameters?