JTAG on bladeRF micro.

Having issues with the site, hardware, source code, or any other issues?
Post Reply
ilya__79
Posts: 1
Joined: Thu May 12, 2022 3:27 am

JTAG on bladeRF micro.

Post by ilya__79 »

Hi! Please help with the next problem.
I’m receiving error when loading custom (simple test, generated in quartus for Cyclone V A9) FPGA bitstream on bladeRF micro(bladeRF 2.0 micro xA9).

«Error (209014): CONF_DONE pin failed to go high in device 1. Make sure all communication cables are securely connected, select a different device, check the power on the target system, or make sure all nCE pins are connected to GND. The Intel FPGA Knowledge Database contains many articles with specific details on how to resolve this error. Visit the Knowledge Database at https://www.altera.com/support/support- ... earch.html and search for this specific error message number.
Error (209012): Operation failed»

When loading thirst generation BladeRF (bladeRF x115 ) using the same JTAG cable and similar test bitstream(generated in quartus for Cyclone IV 115), everything goes fine.
Post Reply