bladeRF x115 - Mac OS 10.11 - gnuradio companion 3.7.11
Posted: Wed Dec 13, 2017 8:07 am
OK Guys and Gals,
I have been playing with the bladeRF X115 and have done the following:
1) Updated firmware
2) Updated FPGA load
When I drop down a simple osmocom source, an FFT and frequency sinks get a nice spectrum, but regardless of where I set the center frequency I ALWAYS see a carrier (-40dBm) and the noise floor (-100dBm or so). I have also tried the "Simple bladeRF RX” GUI from Nuand and have the same problem. I've attached a screenshot of the output to show what I am talking about.
Why are attachments not working?
Thanks,
Herb
I have been playing with the bladeRF X115 and have done the following:
1) Updated firmware
2) Updated FPGA load
When I drop down a simple osmocom source, an FFT and frequency sinks get a nice spectrum, but regardless of where I set the center frequency I ALWAYS see a carrier (-40dBm) and the noise floor (-100dBm or so). I have also tried the "Simple bladeRF RX” GUI from Nuand and have the same problem. I've attached a screenshot of the output to show what I am talking about.
Why are attachments not working?
Thanks,
Herb