Dear All,
I'm trying to install a BladeRF card connected to my MacBookPro.
I'm following these steps (https://github.com/Nuand/bladeRF/wiki/G ... 3A-Mac-OSX ) but I'm stuck in the "Configure the build phase". I downloaded the CMake application and run it (configure and generate) and I'm stoped in $ make command.
Any help will be very welcomed.
Thanks,
António
Issues - Installation in MacOS
-
- Posts: 201
- Joined: Thu Jun 18, 2015 6:10 pm
Re: Issues - Installation in MacOS
Where are you stuck? Is there an error message?
Electrical Engineer
Nuand, LLC.
Nuand, LLC.