bladeRF-cli for 2.0 micro
Posted: Sun Sep 30, 2018 9:10 pm
How can I select the TX/RX channel of the bladeRF 2.0 micro with bladeRF-cli?
Hope this helps
Official bladeRF forum
bladeRF-cli for 2.0 micro
Page 1 of 1
Re: bladeRF-cli for 2.0 micro
Posted: Tue Oct 02, 2018 12:25 pm
"rx config channel=1" would select RX1, "tx config channel=2" would select TX2, etc. You can also "channel=1,2" to select both ports.
Hope this helps
Hope this helps