BLADERF Open Air Interface DC Cal issues
Posted: Wed Nov 28, 2018 1:29 pm
I have a bladeRFx40 and am trying to get my eNB basestation going from openairinterface. I am running 16.04 Ubuntu. My issue is every time I try to run my lte-softmodem with my bladerfx40 config I get the following error.
[DEBUG @fpga_common/src/lms.c:2756] Bad DC_REGVAL detected. DC cal failed.
[DEBUG @fpga_common/src/lms.c:2843] DC Cal retry limit reached
[WARNING @ fpga_common/src/lms.c:3000] DC Calibration (module=1) failed to converge.
Failed to calibrate TX DC: An unexpected error occurred
Aborted (core dumped)
bladeRF> version
bladeRD-cli version: 1.7.0-2018.10-rc1-1-ppaxenial
libbladeRD version: 2.1.0-2018.10-rc1-1-ppaxenial
Firmware version 2.3.1
FPGA version: 0.9.0 (configured by USB host)
On a side note I followed steps at https://github.com/Nuand/bladeRF/wiki/D ... Correction top generate my calibration table and moved the file to the corresponding folder before hand.
Any help and/or troubleshooting is greatly appreciated.
Thanks guys,
Matt
[DEBUG @fpga_common/src/lms.c:2756] Bad DC_REGVAL detected. DC cal failed.
[DEBUG @fpga_common/src/lms.c:2843] DC Cal retry limit reached
[WARNING @ fpga_common/src/lms.c:3000] DC Calibration (module=1) failed to converge.
Failed to calibrate TX DC: An unexpected error occurred
Aborted (core dumped)
bladeRF> version
bladeRD-cli version: 1.7.0-2018.10-rc1-1-ppaxenial
libbladeRD version: 2.1.0-2018.10-rc1-1-ppaxenial
Firmware version 2.3.1
FPGA version: 0.9.0 (configured by USB host)
On a side note I followed steps at https://github.com/Nuand/bladeRF/wiki/D ... Correction top generate my calibration table and moved the file to the corresponding folder before hand.
Any help and/or troubleshooting is greatly appreciated.
Thanks guys,
Matt