Boiler Plate Example not working (MacOS)
Posted: Mon Aug 26, 2019 11:10 am
Operating System: MacOS Mojave (10.14.6)
bladeRF-cli version: 1.8.0-git-994b19a7
libbladeRF version: 2.2.1-git-994b19a7
Firmware version: 2.3.2
FPGA version: 0.11.0 (configured by USB host)
Issue: I copied and built the "boilerplate" configuration example from the libbladeRF documentation site: https://www.nuand.com/bladeRF-doc/libbl ... plate.html. When I run I get the following error:
Failed to set samplerate = 300000: Provided parameter was out of the allowable range
Failed to configure RX channel. Exiting.
Doesn't seem to matter what I set the sample rate to I always get this error.
Other info:
libusb installed via homebrew
build libbladeRF from source (v2.2.1)
downloaded and loaded pre-built binaries for firmware and FPGA
bladeRF-cli version: 1.8.0-git-994b19a7
libbladeRF version: 2.2.1-git-994b19a7
Firmware version: 2.3.2
FPGA version: 0.11.0 (configured by USB host)
Issue: I copied and built the "boilerplate" configuration example from the libbladeRF documentation site: https://www.nuand.com/bladeRF-doc/libbl ... plate.html. When I run I get the following error:
Failed to set samplerate = 300000: Provided parameter was out of the allowable range
Failed to configure RX channel. Exiting.
Doesn't seem to matter what I set the sample rate to I always get this error.
Other info:
libusb installed via homebrew
build libbladeRF from source (v2.2.1)
downloaded and loaded pre-built binaries for firmware and FPGA