XB 200 - Firmware Update

Discussions related to embedded firmware, driver, and user mode application software development
SDR-Radio.com
Posts: 101
Joined: Thu Jul 25, 2013 3:28 am

Re: XB 200 - Firmware Update

Post by SDR-Radio.com »

bpadalino wrote:Going back through your logs I see that you end up setting RXVGA1 to 30dB and RXVGA2 to 20dB. It's recommended in the LMS6002D FAQ in section 5.18 to remove gain from RXVGA2 followed by RXVGA1 followed by the LNA. Can you try to ensure you remove gain in such a fashion? I've seen some interesting things happen when the gain stages are in weird configurations.

Brian
Brian,

Sadly no change - overall gain changes as expected, data still as shown in the screenshot.
SDR-Radio.com
Posts: 101
Joined: Thu Jul 25, 2013 3:28 am

Re: XB 200 - Firmware Update

Post by SDR-Radio.com »

bpadalino wrote:One last thing - the screen shot you posted says the LPF is bypassed which you should not do unless you are already bandlimiting your input signal at the RF input.

The log states the LPF is in Normal mode.

Do you notices differences when you have it bypassed versus in normal mode?

Brian
Brian,

I've tried many combinations as I was also thinking along the same lines. Bypass / anything makes no difference, in fact the changes made to the gains and LNA make no difference, I'm convinced the issue is in the area of firmware / libusb. I'm just about to try libusb 1.0.19, then I'll put together a full static build of all the code (libusb, libbladerf) and take it from there.
SDR-Radio.com
Posts: 101
Joined: Thu Jul 25, 2013 3:28 am

Re: XB 200 - Firmware Update

Post by SDR-Radio.com »

One thing I failed to mention - I am using Windows 8.1 .
Post Reply