Problem when adding source files for Nios2
Posted: Thu Feb 24, 2022 3:39 am
Hello,
I am using BladeRF micro 2.0 A9 ,
bladeRF-cli version : 1.8.0
libbladeRF version : 2.2.1
Firmware version : 2.3.2
FPGA version : 11.0.0
I am trying to automatically set rx frequency, gain, samplerate ect... when a reception occures. To do that i added new source files in bladeRF_nios folder and to set rx parameters i use rfic_command_write_immed() function. The code compile well and i can generate the bitstream but when i load it on the FPGA i get the following errors:
-Failed to receive Nios2 response : operation timed out
-Failed to read FPGA version : operation timed out
(When i use the JTAG i don't have this problem).
Any advance users of BladeRF here that is keen to point me to the right direction?
Thanks,
GC.
I am using BladeRF micro 2.0 A9 ,
bladeRF-cli version : 1.8.0
libbladeRF version : 2.2.1
Firmware version : 2.3.2
FPGA version : 11.0.0
I am trying to automatically set rx frequency, gain, samplerate ect... when a reception occures. To do that i added new source files in bladeRF_nios folder and to set rx parameters i use rfic_command_write_immed() function. The code compile well and i can generate the bitstream but when i load it on the FPGA i get the following errors:
-Failed to receive Nios2 response : operation timed out
-Failed to read FPGA version : operation timed out
(When i use the JTAG i don't have this problem).
Any advance users of BladeRF here that is keen to point me to the right direction?
Thanks,
GC.