Question about ADS-B setup mentioned in blog

Discussions related to embedded firmware, driver, and user mode application software development

Moderator: robert.ghilduta

Post Reply
Montezuma
Posts: 35
Joined: Fri Mar 01, 2013 6:42 am

Question about ADS-B setup mentioned in blog

Post by Montezuma » Tue Jun 14, 2016 1:52 am

I was reading about the ADS-B decoder on the Nuand.com blod: https://www.nuand.com/blog/bladerf-vhdl-ads-b-decoder/. I have a question, which may be either really "noob-ish" of me, but what program is pictured under the "What are ADS-B and Mode-S?" heading? The program I am inquiring about is pictured here: https://www.nuand.com/blog/bladerf-vhdl ... _modelsim/

My eyes are bad, and I haven't been able enlarge the photo enough to make out the title of the window, any of the menus, or the function buttons. Any information is appreciated.

Thanks guys.

jynik
Posts: 455
Joined: Thu Jun 06, 2013 8:15 pm

Re: Question about ADS-B setup mentioned in blog

Post by jynik » Tue Jun 14, 2016 9:32 am

I believe that is the Altera Edition of ModelSim.

I'm assuming that this is showing data captured with the bladeRF-cli being run through a simulation of the ADSB core.

Post Reply