Led Voltage

Discussions related to schematic capture, PCB layout, signal integrity, and RF development

Moderator: robert.ghilduta

Post Reply
Posts: 2
Joined: Mon Sep 04, 2017 4:42 am

Led Voltage

Post by Gunzmo » Fri Sep 08, 2017 4:29 am

Hi again,

What I can understand is the Voltage of Led1-Led3 is 0.4 voltage when it's off and around 2 voltage when activated.

I can't test Led1-Led3 at the moment (driver issues with Windows) so I checked the power led and it was around 2 voltage more exact 1.8 voltage.
Is it the same for Led1-Led3 aswell?

Why im asking is because I wanna connect the Leds to a ADC so I can see the TX and RX on screen instead of looking at the leds.

Posts: 202
Joined: Thu Jun 18, 2015 6:10 pm

Re: Led Voltage

Post by bglod » Fri Sep 08, 2017 10:45 am

I guess I'm not sure what you're trying to accomplish. The LEDs are simply on or off based on a counter inside the FPGA.

You may also want to take a look at the schematic. Page 3 should have the information you're looking for.
Electrical Engineer
Nuand, LLC.

Post Reply