bladeRF Micro Single board phase coherency
Posted: Fri Jul 19, 2019 9:34 pm
Looking over the AD9361 Datasheet I see that the two receive channels use the Same Local Oscillator. So I browsed around and found that some are saying that this should enable the 2 Rx channels on same board should to be phase coherent. Does this mean the 2 RX channels on a bladeRF micro are coherent? If they are not "out of the box" would there be an FPGA configuration that could make this the case?
Also, I did see the bladeRF micro phase coherency topic, but that was asking about synchronizing multiple boards.
Also, I did see the bladeRF micro phase coherency topic, but that was asking about synchronizing multiple boards.