I am trying to simulate the example design of the bladeRF x115 but run in to some errors in ModelSim.
when i run the compile.do file i get the error:
# ** Error: (vcom-11) Could not find work.tx.
# ** Error: (vcom-11) Could not find work.rx.
The work.rx and work.tx are used in the sample_stream_tb.vhd file but I couldn´t find where these entities are instantiated.
Could anyone help me out solving this error and simulating the design?
Discussions related to schematic capture, PCB layout, signal integrity, and RF development
1 post • Page 1 of 1