Page 1 of 1
bladeRF simulink module problems
Posted: Tue Feb 09, 2016 11:04 pm
1. what does those parameter mean ?
2. and what kind of value do i input to the bladerf Tx sink ?
thanks u guys very much!!
hello, i have some questions in the bladeRF sinulink block
Re: bladeRF simulink module problems
Posted: Fri Feb 12, 2016 7:46 am
The MATLAB and Simulink support is implemented as a wrapper around libbladeRF. As such, you can find more information about what all these parameters mean via the libbladeRF API docs
In particular, these values correspond to the values passed to bladerf_sync_config()
. This page
describe this in a bit more detail.
The only parameter that not's in there is the "Number of samples to TX during each simulation step" -- this is specific to MATAB. This defines how many samples should be processed (i.e., RX'd or TX'D) in the block for each time Simulink runs this block.
You should input complex values in the range [-1.0, 1.0) to this the TX sink.