I am trying to take an output (logic 1 or 0) from an Arduino-board and use it as an input on my BladeRF and process that input and transmit a message accordingly. However, I am not sure how to take an input on my bladeRF. I have seen the xb-100 expansion boards, but they are very expensive and I can't afford it at this time. Is there maybe a way to utilize any of the JTAG (or other) pins for (I2C/SPI/GPIO etc)?
I am using the BladeRF x40 Rev. 2.
Off topic threads and discussions
2 posts • Page 1 of 1