Blade 2.0 micro xA4 - GPS spoofing

[hyp3v]

Hey guys,

I have this script for the bladeRF 2.0 xA4:

Code: Select all

set frequency tx1 1575.42M
set samplerate tx1 2.6M
set bandwidth tx1 2.5M
set gain tx1 66
set gain tx1 dsa 0
tx config file=gpssim.bin format=bin
tx start
tx wait

It seems only to transmit for far less than one minute (observed with xgps). not enough to get a fix.
I also noted that these commands were deprecated for my bladeRF: (for DC offset)

Code: Select all

cal lms
cal dc tx

But I don't know if it is relevant to the problem since I think with this version the DC offset is automatic.

Note that gpssim.bin is a 8 bit I/Q data file generated from gps-sdr-sim supposed to last for 3 minutes.
Also, I can spoof with success in my lab with my hackrf.

Thank you for the help!

[Rickie Yost]

You can try adjusting parameters like frequency, sampling rate, bandwidth,Geometry Dash Online and gain to see if signal transmission is maintained longer.

[helow]

Hey guys,

I have this script for the bladeRF 2.0 xA4:

Code: Select all

set frequency tx1 1575.42M
set samplerate tx1 2.6M
set bandwidth tx1 2.5M
set gain tx1 66
set gain tx1 dsa 0
tx config file=gpssim.bin format=bin
tx start
tx wait

It seems only to transmit for far less than one minute (observed with xgps). not enough to get a fix.
I also noted that these commands were deprecated for my bladeRF: (for DC offset)

Code: Select all

cal lms
cal dc tx

But I don't know if it is relevant to the problem since I think with this version the DC offset is automatic.

Note that gpssim.bin is a 8 bit I/slope game Q data file generated from gps-sdr-sim supposed to last for 3 minutes.
Also, I can spoof with success in my lab with my hackrf.

Thank you for the help!

Take my hand and start exploring the wonderful things ahead