Hello,
published bladeRF for calibration isn't good for dummies at all.
What's the best way to calibrate bladerf in order to use YateBTS ?
like:
1. bladeRF-cli -i
2. set rxvga2 27
3. set rxvga1 25
4. set txvga2 -14
5. set txvga1 0
4. cal table dc rx 1841.6M 1842M 1000
5. cal table dc tx 1841.6M 1842M 1000
like this?
or it should be standard cal table dc tx/rx without freq ?
bladeRF calibration for yatebts/openbts
-
- Posts: 62
- Joined: Fri Mar 01, 2013 3:58 am
- Location: Silicon Valley
- Contact:
Re: bladeRF calibration for yatebts/openbts
You can get quite a bit more transmit power output by setting txvga1 and txvga2 higher. For the best linearity, I suggest:
txvga1 = -8
txvga2 = 20
Ron
txvga1 = -8
txvga2 = 20
Ron