Establish FSK bridge
Posted: Wed May 29, 2013 1:56 pm
Hey,
I'm persisting an issue here, which I find problematic... to continue my stuff. You can find me on IRC in #bladerf - I use the same nick.
1. I attach my my bladerf, and the kernel extension is loaded
2. I take a look at dmesg and check my /dev
The USB2.0 fallback is due to some issues with the USB3 controllers - which are not necessarily a big problem, because I just do the GR blocks. It should not matter.
3. and I see that this isn't what I was looking for.
Now what I need is:
[*]How do I set the jumper / trigger (with the JTag) for a tx/rx mode change now? - I need both (JTag & USB protocol)
[*]Where do I find the API to set/get the sink or source via USB... set freq/gain etc.? Is there any, or should I start here?
Any enlightenment I missed to far? The host utils could be integrated into GrOsmoSDR or libhackrf... however I'd need to check the FSK stuff is compatible and it's fast enough
Best,
Marius
I'm persisting an issue here, which I find problematic... to continue my stuff. You can find me on IRC in #bladerf - I use the same nick.
1. I attach my my bladerf, and the kernel extension is loaded
2. I take a look at dmesg and check my /dev
Code: Select all
[84191.354318] usb 2-1.5: USB disconnect, device number 13
[84191.354881] nuand_bladerf 2-1.5:1.0: Nuand bladeRF device has been disconnected
[84191.355431] nuand_bladerf 2-1.5:1.1: Nuand bladeRF device has been disconnected
[84191.355917] nuand_bladerf 2-1.5:1.2: Nuand bladeRF device has been disconnected
[84193.842681] usb 2-1.5: new high-speed USB device number 14 using ehci-pci
[84193.938437] nuand_bladerf 2-1.5:1.0: Nuand bladeRF device is now attached
[84193.939019] nuand_bladerf 2-1.5:1.1: Nuand bladeRF device is now attached
[84193.939547] nuand_bladerf 2-1.5:1.2: Nuand bladeRF device is now attached
Code: Select all
✘ wishi@sheep ⮀ /dev ⮀ ls | grep blade
bladerf0
bladerf1
bladerf2
Now what I need is:
[*]How do I set the jumper / trigger (with the JTag) for a tx/rx mode change now? - I need both (JTag & USB protocol)
[*]Where do I find the API to set/get the sink or source via USB... set freq/gain etc.? Is there any, or should I start here?
Any enlightenment I missed to far? The host utils could be integrated into GrOsmoSDR or libhackrf... however I'd need to check the FSK stuff is compatible and it's fast enough
Best,
Marius