Official bladeRF forum

I tried to generate a sine wave using bladeRF but I couldn't get a clear for all sample rates. I could get a sine wave when my sample rate is below 2.5MHz. So is there any way to determine the maximum sample rate for the device. Further is there any relation between bandwidth and sample rate.

Hi,
I tried your wiki and I was getting a gap of 1, but in between I sometimes got a gap of high positive and negative value (10^3 - 10^4 or even more) at 4MHz sampling rate. I further decrease my sample rate to 2 MHz but was getting the same problem. So to decide my maximum sample rate do I have to do hit and trial such that I get a gap of just 1 or is there same other method.


Thanks

Yes all my bladerf stuff are up todated. My system is a hp lenevo g6, 2nd generation i5. I am running Ubuntu 12.10 and I haven't tried it on other system. Further I'm using USB 2.0.