Official bladeRF forum

I'm having an issue with the CLI in windows that i do not have in linux. When transmitting as shown in the second picture the cli freezes. Ive also tried to re-transmit the .csv captured from the rx function to see if improperly formatted the .csv but the same result occurred.

I've done this at low sample rates and high as well.

Has anyone else experienced this?

bladeRF> info

Serial #: 210588cbbd9541
VCTCXO DAC calibration: 0x8a68
FPGA size: 115 KLE
FPGA loaded: yes
USB bus: 1
USB address: 2
USB speed: SuperSpeed
Backend: libusb
Instance: 0

bladeRF> version

bladeRF-cli version: 0.10.3-git
libbladeRF version: 0.12.1-git

Firmware version: 1.6.1-git-b7
FPGA version: 0.0.4