Issues - Installation in MacOS

Having issues with the site, hardware, source code, or any other issues?

Moderator: robert.ghilduta

Post Reply
antoniobrito
Posts: 1
Joined: Sat Mar 10, 2018 10:21 am

Issues - Installation in MacOS

Post by antoniobrito » Sat Mar 10, 2018 10:27 am

Dear All,

I'm trying to install a BladeRF card connected to my MacBookPro.
I'm following these steps (https://github.com/Nuand/bladeRF/wiki/G ... 3A-Mac-OSX ) but I'm stuck in the "Configure the build phase". I downloaded the CMake application and run it (configure and generate) and I'm stoped in $ make command.


Any help will be very welcomed.

Thanks,
António

bglod
Posts: 187
Joined: Thu Jun 18, 2015 6:10 pm

Re: Issues - Installation in MacOS

Post by bglod » Wed Mar 14, 2018 1:20 pm

Where are you stuck? Is there an error message?
Electrical Engineer
Nuand, LLC.

Post Reply