Operating System: MacOS Mojave (10.14.6)
bladeRF-cli version: 1.8.0-git-994b19a7
libbladeRF version: 2.2.1-git-994b19a7
Firmware version: 2.3.2
FPGA version: 0.11.0 (configured by USB host)
Issue: I copied and built the "boilerplate" configuration example from the libbladeRF documentation site: https://www.nuand.com/bladeRF-doc/libbl ... plate.html. When I run I get the following error:
Failed to set samplerate = 300000: Provided parameter was out of the allowable range
Failed to configure RX channel. Exiting.
Doesn't seem to matter what I set the sample rate to I always get this error.
Other info:
libusb installed via homebrew
build libbladeRF from source (v2.2.1)
downloaded and loaded pre-built binaries for firmware and FPGA
Boiler Plate Example not working (MacOS)
-
- Posts: 156
- Joined: Thu Feb 28, 2013 11:14 pm
Re: Boiler Plate Example not working (MacOS)
To enable more verbose logs, try to call bladerf_log_set_verbosity() with BLADERF_LOG_LEVEL_VERBOSE .
Afterwards, could you please try to set the samplerate and bandwidth to 2000000 for both RX and TX?
Afterwards, could you please try to set the samplerate and bandwidth to 2000000 for both RX and TX?