My application involves using multiple bladeRFs at the same time. i want to transmit a given tone signal via a particular bladerf and other through 2nd Bladerf both connected on different usb ports of my laptop. i am using a single Osmocom Sink block and using Num Channels value as 2 to allow simultaneous operation of 2 bladerfs. However i am unable to comprehend the way GRC gives the id i-e [bladeRF sink] Using nuand LLC bladeRF #0 SN d543.. or [bladeRF sink] Using nuand LLC bladeRF #1 SN 3d83 to either bladerfs. the only part i am sure is that it is not dependent upon Serial number of bladerf. is it dependent upon the usb addresses or wat ? (ID changes as i switch between various usb ports)
Secondly can i direct a signal onto a particular bladerf using its serial number or any other such property, maybe through Device Arguments field etc in Osmocom Block ? if yes then How ?
Thanks in Advance ..
Multiple Bladerf usage [Solved]
-
Hamza
- Posts: 6
- Joined: Wed Jan 28, 2015 8:32 pm
Multiple Bladerf usage [Solved]
Last edited by Hamza on Wed Apr 29, 2015 10:27 am, edited 2 times in total.
-
Hamza
- Posts: 6
- Joined: Wed Jan 28, 2015 8:32 pm
Re: Multipe Bladerf usage
Hi Jon,
That was indeed very useful. Helped me in better understanding of basic concepts.
Stay Blessed
Regards!
That was indeed very useful. Helped me in better understanding of basic concepts.
Stay Blessed
Regards!